VMware

A.K.A Why not to use snapshots I ran into a slightly confusing problem today - our SQL servers are all created with 4 disks on 4 separate LUNs (System, Swap, SQL Data and SQL Logs). When viewing the server through Virtual Center I couldn’t see all of the LUNs, just the System LUN. It’s not a major problem as the VM can see the storage, but a little annoying when you have to remember what LUN the disks are on.

Here’s the setup. We have a core switch of 2 Cisco 3750s, connected together for fault tolerance as a single logical switch; we also have several ESX 3.5 hosts with 4 Gigabit Ethernet NICs installed each. The Virtual Machines will all be on VLAN 8 (reserved for internal servers) and the VMKernel will be on VLAN 107 (reserved for VMKernel traffic like VMotion). I want to create a load balanced, fault tolerant aggregate of these four NICs over the Core Switch.

Having just rebooted my laptop, I clicked on the link to open VMWare Infrastructure Web Access in the my browser and was slightly puzzled by the “page cannot be displayed” error. I figured it was probably the VMWare Server Web Access service not starting for some reason, so I opened services.msc and checked it out. The Web Access service was actually running, but the Host Agent service was not, so I tried to start it - it failed.

Having recently installed an ESXi server, I am getting to grips with the management and administration of it, one of the things that I wanted to be able to do was connect to the remote terminal through SSH. I downloaded my SSH client of choice, PuTTY, and set about connecting, however the server refused the connection. It seems that SSH is not enabled out of the box for ESXi and you need to go through some steps to get there - I found some helpful hints here.

We recently needed to upgrade one of our applications, and the new version requires an addition server instead of the application and SQL it requires a back end search, a front end web server and a SQL server. The specifications of the new server which are “required” to qualify for support are pretty high. The problem is that the actual processor usage is very light, and it is very hard to justify buying a whole new server that I know is going to be barely used.

I’ve just upgraded my VMWare Server install to the latest version of the VMWare Server beta, which I have to say, is looking pretty good! One slight niggle that I had was that when I opened the VMWare Remote Console it would tell me that I could not connect, with the error: Error opening the remote virtual machine SM-00109:8333\16: The host name could not be resolved. Clearly THAT’s a pain in the proverbial.

I’ve recently had to upgrade my VM Server due to an increase in load. I had 2 virtual servers running off of the same hard disk, with 768mb of RAM split between the lot. After jamming 2 new 1GB sticks of DDR in, and a new 120GB hard drive it was time to re-allocate some of these resources…here’s how: WARNING! You should always perform a backup on a server you can’t afford to lose BEFORE any operation that could potentially destroy the disk (think what would happen if you had a power cut while resizing…) Step 1 - Moving the Virtual Server.