Here's the setup. We have a core switch of 2 Cisco 3750s, connected together for fault tolerance as a single logical switch; we also have several ESX 3.5 hosts with 4 Gigabit Ethernet NICs installed each. The Virtual Machines will all be on VLAN 8 (reserved for internal servers) and the VMKernel will be on VLAN 107 (reserved for VMKernel traffic like VMotion). I want to create a load balanced, fault tolerant aggregate of these four NICs over the Core Switch.
I recently resolved an ongoing DNS issue where the Active Directory Integrated DNS was loaded in both the Domain and the DomainDNSZones partition of AD - this is a separate issue and should be resolved differently. My problem when I tried to verify that the fixed DNS setup had propogated around my domain controllers, DC01 and DC02. DC01 kept failing “DCDIAG /TEST:DNS” with errors regarding the root hint servers. Googling about it was clear that a lot of people were suffering the same issue, but no article I read had correctly identified the solution.
Having recently installed an ESXi server, I am getting to grips with the management and administration of it, one of the things that I wanted to be able to do was connect to the remote terminal through SSH. I downloaded my SSH client of choice, PuTTY, and set about connecting, however the server refused the connection. It seems that SSH is not enabled out of the box for ESXi and you need to go through some steps to get there - I found some helpful hints here.
I was configuring our new Cisco ASA 5510 firewall today, as part of a major infrastructure upgrade. I'm pretty comfortable with the Cisco IOS, but I still prefer the GUI for the basic set up, using command line to tweak the finer or more complex configurations. However, straight out of the box, I had a very hard time getting the ASDM to load. Being familiar with the PDM from the PIX range of firewalls, I should have guessed the problem straight away.